Abstracts - faqs.org

Abstracts

Science and technology

Search abstracts:
Abstracts » Science and technology

Cyclic deformation and anisotropic constitutive relations of Al-6061-T6 under biaxial loading

Article Abstract:

The stress, strain and anisotropic properties of the Al-6061-T6 plate at multiaxial loading condidtions are studied. Two orientations of specimen made from Al-6061-T6 material are subjected to reversed cyclic tests under three loading conditions, namely: tension/compression, torsion and combined tension/torsion in-phase. A biaxial extensometer is used to measure the system strain. The results are then presented in the form of cyclic stress-strain curves. Results indicate that the cyclic stress-strain curves along the rolling and transverese direction of the plate are anisotropic.

Author: Hong Lin, Nayeb-Hashemi, Hamid, Pelloux, R. M.N., Berg, C.A.
Publisher: American Society of Mechanical Engineers
Publication Name: Journal of Engineering Materials and Technology
Subject: Science and technology
ISSN: 0094-4289
Year: 1992
Methods, Dynamic testing (Materials), Stress analysis (Engineering)

User Contributions:

Comment about this article or add new information about this topic:

CAPTCHA


Fatigue life parameter for Type 304 stainless steel under biaxial-tensile loading at elevated temperature

Article Abstract:

A damage parameter for predicting fatigue life under biaxial-tensile loadings was described. Past studies focused on situations where the in-plane biaxial stress ratio was negative. However, cases where principal stresses in tension were involved have received little attention. Thus, a testing method was used to carry out biaxial fatigue tests. The obtained experimental data were compared with the predictions of the proposed parameter and the correlation between the experimental fatigue lives and applied stress states was discussed.

Author: Bernard, Marie, Zouani, Abdelkrim, Bui-Quoc, Thang
Publisher: American Society of Mechanical Engineers
Publication Name: Journal of Engineering Materials and Technology
Subject: Science and technology
ISSN: 0094-4289
Year: 1999
Analysis, Fatigue (Materials), Stainless steel, Metal fatigue, Steel, Steel, Stainless

User Contributions:

Comment about this article or add new information about this topic:

CAPTCHA



Subjects list: Research, Materials, Strains and stresses, Stresses (Materials)
Similar abstracts:
  • Abstracts: Mediated conditioning and retrospective revaluation with LICL then flavour pairings. Contextual control of appetitive conditioning: influence of a contextual stimulous generated by a partial reinforcement procedure
  • Abstracts: Cyclic stress-strain behavior and low-cycle fatigue of Ti 6-4 at 260 degrees centigrade. Significance of the relative orientation of the mean and alternating principal stress axes in biaxial fatigue
This website is not affiliated with document authors or copyright owners. This page is provided for informational purposes only. Unintentional errors are possible.
Some parts © 2025 Advameg, Inc.