Fit and cleanliness

Article Abstract:

Wokring diligently to ensure that a solder seam has the closest possible fit is essential in jewelry making. Preparation is key in producing a good fit. Keeping parts and hands clean is also important.

Solder and soldering, Soldering, Solders

---

Using a design source

Article Abstract:

Directions for making an intermediate-to-advanced piece of jewelry from a design source are given. The piece shown is metal work with a pearl set in it.

Jewelry

---

Common questions on design

Article Abstract:

Twelve questions about jewelry design are addressed. The subjects all address the different areas of creativity needed for the process.

Similar abstracts:

• Abstracts: Plane Jane chinas. Miniature delights. S.F.B.J. made in impact
• Abstracts: Ziroli plans and sheeting with balsa. Sheeting with obechi. Edge-join balsa sheeting
• Abstracts: Top Gun tidbits and hatches. Strong, scale, control surfaces. Cyber Komet and easy scale hinges
• Abstracts: Heavenly peridot. Going Dutch. Obsidian is a gem?
• Abstracts: Making mokume gane. Casting a gold pendant: part IV: finishing the pendant. Fire scale: removal, accommodation, and prevention

This website is not affiliated with document authors or copyright owners. This page is provided for informational purposes only. Unintentional errors are possible.